Zinc, brass and copper all have surfaces which rapidly discolour when presented to air, shaping an unmistakable matt layer, or 'patina'.

The patina increments after some time and responds with fluids and different materials to make a particular tasteful. Brass will discolour speedier if presented to warm sources.

Holding the first brilliant sparkly surface requires a surface security, for example, varnish or extremely customary cleaning.

Beeswax is frequently connected amid assembling, which secures the surface and moderates patination.

Metal surfaces can keep going for a long time, if kept up – the most widely recognised reasons for harm are scratches and marks on their edges. Most metal tops have metal edges and these edges can be helpless against thumps and to rehashed development, in the long run coming free.

Cleaning Brass, Copper & Zinc Table Tops

Use warm water and cleanser to clean patinated and non-patinated surfaces. Rub less hard on patinas, which will be diminished with an excessive amount of consideration.

Maintaining Brass, Copper & Zinc Table Tops

To keep up cleaned zinc, copper or brass, we prescribe using a restrictive clean, for example, Brasso following the directions on the item. This should be rehashed routinely, as the metal stains.

To moderate a patina shaping and to secure the surface we suggest applying an unmistakable rich beeswax, once at regular intervals or when a surface begins to dull.

On the off chance that you lean toward a patina to grow, just clean the surface as depicted above, as opposed to cleaning it, and watch the character show up. Especially unmistakable checking can be cleaned out, in spite of the fact that this will obviously expel the patina.

To evacuate further scratches, use sandpaper to decrease the encompassing surface thus 'expel' the scratch. Doing this requires fine sandpaper (at any rate toward the finish of the procedure) and the surface may then require an exhaustive clean.

We recommend you use Realy Spray for your table cleaning needs